O-E34/O-E35/E51/E66/O-E67; O-E43/E58/E83/E110 - Pentax 67 II Service Manual

83 O-E34 (2nd curtain pinion shaft), O-E35 (1st curtain pinion shaft), E51 (Curtain roller B),
E66 (Curtain pipe retainer screw), O-E67 (Shaft plate A)
1) Remove temporarily assembled E48,
E52 and O-E49
from
O-E.15.
2) lnsert O-E.35 in O-E67 and apply
appropriate quantity of L31 oil to
O-E67 and O-E.15 contact parts.
3) Attach E48, E52 and O-E49 to
O-E35, fasten with E66 x3, and
check for vertical looseness in O-E35.
4) Apply screw lock(1401 C) to E66 x3 .
5) Insert O-E34 into O-E67 and
apply appropriate quantity
of
L31
oil from two vertical places
on O-E67 and O-E34 contact parts.
6)Attach in the order B51, W8 t=0.1
(adj.)
O-E41, and fasten with E66.
Check that vertical looseness of O-E34
is 0.2 mm+/- 0.1.
If
outside this range, adjust with W8.
7) Apply screw lock (1401C) to E66.
O- E35
8.4 O-E43 (2nd curtain pipe), E58 (2nd spring shaft collar), E83 (Curtain shaft wheel),
EllO (Curtain shaft pedestal)
- 0-E34
1) Apply appropriate quantity of L31 oil to shaft section of O-E43, push down shaft and apply appropriate quantity of
L31 oil to shaft section (inside lock washer). Move shaft section up and down and spread L31.
2) Insert E58 into O-E43 shaft section, hold with screwdriver and attach E83.
58170
<S/-EB3
t
n....---Driver