O-D1, E93; D130 X2 - Pentax 67 II Service Manual

NB : When replacing the Mount, follow the procedures be.low
B2 (Mount),
B3 (Mount spring) x3,
H4 (Mount stopper)
*
Apply G31 generously to the diagonal line face
and end face of B3 x3 as shown in the drawing.
*
Apply Arontite (red) to the CNS 1.7 x2.2 x8 screw section,
and tighten the screws.
6.16 0-Dl (Mirror base plate), E93 (Shaft plate retainer screw)
[Tool: 95901-N035 (23400-BOl-A) Mirror 45 degrees checker
1) Apply G31 as shown in Fig. A and Fig. B
2) Insert 0-Dl into the body.
~)
While putting the swing lever into the hole of the mirror box, insert the 0-Dll section into
the long groove of O-D125 and install 0-Dl.
3) Screw tight with E93 x2, CNS 1.7 x3.0.
4) Set the Mirror box at the charged state, screw in D148 x2, to create the gap between
the mirror seat and the damper plate
5) Check : Parallelism of mirror.
Adjust: Move O-D126 at the mount lock pin side.
6) Tighten O-D126 installing screw x2, apply Three Bond 1401C to the screw bead.
7) Check : Mirror 45 degrees check with the Jig.
Adjust: In/Out of D148 at the driving mecb. side.
When adjustment done, in/out same amount of D148 at the mount lock pin side,
and fix with D149.
Fig. A - -
~
Fig. B
6.17 D130 (Light seal tape) x2
I.Affix D130 so as to block the gap
between the Mirror box and O-D126.
0130
~···.
~
' '
~ -
:
--
.:
:
: e:::i
I
!
'
'
.....
'
0-~~
26
27340
0-0126
43170