Winding Stopper Position; Charge Gear Position - Pentax 67 II Service Manual

3) Apply G31 generously to BOl .O (15 each ahove and below)
and attach 0 -Cl (main gear).
4) Install 0-Cl vertically and attach to shaft while taking care
that 1301.0 docs not protrude.
5) After attaching 0-Cl thoroughly, move O-C28 (Winding ratchet)
and rotate 0 -Cl clockwise until it stops.
6) C53, C52 (drawn surface ou top)
Attach C53 to the long bole of C52, rotate clockwise
180 degrees, and attach with CNH-G2 x3.5.
(Apply the Screw loci)
7) C86, ClOO, CNL-Dl.7 x2.5
Move C86 anti-clockwise and fasten the bole
at front right with screws.
8) Attach the temporary winding lever (C51)
to prevent users' items becoming scratched .
9) C27 (-OlG: standard use), CSS2 x4.0 x2
In order to prevent contact with C86,
wind the winding lever 160 degrees and attach C27.
2.5 Winding stopper position (adjust)
1) Check: Slowing wind with the winding lever
and when stopped in a position with
the ratchet (O-C28) reversed,
check that the gap between 0-Cl
and C27 is between 0.2 and 0.5 mm.
2) Adjust: Replace C27 types. __,.
C27-01G, -OlE, -OlF
O-C1
C27
-OiG
-OlE
-OlF
a (mm)
4.8
5.0
5.2
3) After adjusting and check, apply the Screw lock
to the screw sections of CSS2 x4.0 (2) and
check a second time.
~fl
2.6 Charge gear position (adjust)
1) 0-E80 (curtain charge gear)
(55 2.0X4.~ 2 ~ ~
c27---0J
I
CNM
1.7x4.0
1~~r~
~ ~~ 1
® ----- C NH-G 2Dx35
19
(52
so1.o x1 s IG31 I
ID Mark (Left, Right)
0
I
0
I
I
I
-
I
-
I
------·-.------···-
0 I
-
I
b
E79
1
-
-1) Set the winding lever in the housed state.
-2) W51 (t=0.3, adj.)
-3) O-E80 (-OOB: standard used), attach so that
the dowel at the rear faces true left (Back cover key side).
-4) E79 (apply G21 to shaft part of O-E80).
~ ~ -
W51(l=0.3 , adj.)
~ : 0 -,
@)
2) Check: Slowly wind and check for the following order
((1)--7@-l>@).
NB: Do not wind forcibly if there is a large gap between
®
and
@.
The gap should be small. In order to release during winding,
bold the winding lever and move the ratchet.
<D
1'
1
curtain stopper (upper E82 stopped)
®
2"d curtain stopper (lower E82 stopped)
@
Ratchet (0-C28) reverses
(Gap between 0-Cl and C27 between 0.2 and 0.5 mm)
27340
O-E80
-OOA,B,C
Back cover key side
~
(O-A41)
Bno