Mechanical Back, Mirror Or 45 Degrees, Mount Lock Pin - Pentax 67 II Service Manual

7) Solder 6 lead wires (lower side of body TlOO).
8) Using the guide of the mirror box, treat the lead wires
so that they do not come into contact with the gears
and the bounce mechanism.
-7
Purple
Pink
2.16 Mechanical back, mirror 45 degrees, mount lock pin (adjust)
Equipment to be prepared: Block gauge for 67,
Mount pedestal for 67,
1) Adjust: Mechanical back
Mirror 45 degree positioning jig for 67,
Slide calipers.
-1) Check: Set the Back cover vertically and measure six places.
Standard: 84.95 +/- 0.04 mm
-2) Adjust: Remove the mount ring and adjust with W8 (four places)
±
0.02 as the objective.
2) Adjust: Mirror 45 degrees
ed
White
a.
b.
c.
d. e.
t.
-1)
Check: In the winding completion state, place the jig against the mirror and the mount and make sure that there
;, nn g•p bo1w~ mimu. (Chock in tb.::" pl~"·) C
-2)
Loosen
Dl49 (2),
screw in
Di48 (2),
and create a gap
between the mirror sheet and the damper plate. (D132, D133).
-3) Adjust 1: Adjust the mirror angle with D148 on the grip side.
-4) Adjust 2: Adjust to zero the gap between the mirror sheet
and D133 with the other D148.
-5) Fix with D148 (2) and check again.
After adjusting and checking, apply screw
Jock D148.
27340
L1
nno