O-D1 Assembly; O-D11/O-D14/D17, Etc.; D24/D26/D31/O-D32, Etc. - Pentax 67 II Service Manual

7. 0-01 (mirror base plate) assembly
7.1 0-Dll (Mirror actuator arm), 0-014 (Center gear assy.), D17 (Mirror operation plate), etc.
[Adhesive! : 9590 I S 120 (Arontitc red 50cc)
1) Apply G21 lo outer circumfrrence of cam of O-D14, bore of O-D14, and shaft section of 0-DJ 1.
2) lustall O-D14 into 0-Dl shaft, tum to right, aud briug up agaiust stopper.
3) Attach book of Dl 7 to Dl 9, tum to right by 180
+/-
30 degrees, latch D17 at place marked with au asterisk,
and install above O-Dl4.
Note: Use a black marker pen at Dl 9 hook position of 0-014 to facilitate assembly.
4) Align book sectiou of 0-Dl 1 with protruding part side (45 degrees to lower left) of 0-01, attach in alignment with
square bole of Dl 7, apply Arontite (red) to screw section of CNL-G2.0 x3.5, and fasten.
Do not apply G21 *-mark
:~--- ~
··--[fil]
'
.
'
: -.
'
\ 0 •
\,.. \t«
0-014 Rear side
•
014
019
Marker
02
Mark for spring hook
7,2 D24 (Restoring gear), D26 (Mirror restoring spiral spring shaft), D31 (Swing lever spring),
O-D32 (Diaphragm charge gear), etc.
1) Apply G21 to bore of O-D32 and three places each on upper and lower protrnsions (convex).
2) Insert O-D32 into pillar of 0-Dl and align pin of O-D32 with 0-Dl lever hole.
3) Apply G21 to bore section of D24 and insert D24 into 0-Dl pillar as in drawiug so that outer circumference side of
D27 spring hook comes in a position within 40 degrees from standard.
4) Attach hook A or B of D26 to hook on bore of D27 spiral spring,
tum anti-clockwise by 135 +/- 20 degrees,
and install D26 in 0-Dl square shaft.
5) Apply G21 to two places on bore of D31 hook part and latc!J on to upright parts of each as shown in drawing.
024
~HookB
~-026
Hook A
Black marker pen
027
Spring hook position mark
CNL-Gl . 7x3.S-~
rn
135±20 deg. (Anticlockwise)
026--(~'-A
027~~
\B ----- 0 27 spring boo.._ 5ect1on
024
~:::i
-,----
' .
.
G21 (Bore , convex section both side)
53170