Winding Lever Click Switch; Multiple Exposure Restrict Plate; External Lcd Support Plate - Pentax 67 II Service Manual

3) Check l : When the armature is released adsorption,
the gap between O-C25 and O-C28 should be
more t.han 0.1 mm.
Check 2: When winding again, the pointed part of O-C25
should he engaged with O-C28 as shown in drawing.
Adjust: Adjust with the eccentric dowel of O-E91.
(Do not bend O-E9 l)
4) After adjusting as above, apply Screw lock (or adhesive) to
S300 inst alling screw and o-E91 eccentric dowel.
When wind on after adjustment, move O-C25.
5) Check: During winding, C97 (ratchet spring) should come
securely into contact with C84 (winding halfway switch)
11 (eleven) times.
2.9 Winding lever click switch (C89, C90)
1) Set during winding.
2) C89, C73, C90, C39, CNL-El.7 x2.0
3) Adjust: Gap of Winding lever click switch
C90 should be adjusted so that the switch gap is
between 0.1 and 0.3 mm in the Winding lever is
at preliminary angle position.
4) Check: Check switch operation.
a) Winding lever housing position: SW/off
b) Winding lever preliminary angle position:
SW/off (0.1 - 0.3 mm)
c) During winding: SW/on
5) One lead wire (pink) should be soldered onto C90.
~\c
O-C28
/~
>0.1mm
~~~c~
adj .
~
CNL-E1 .7x2.0
®--c39 __ _
, /
-,,
C90
/~ 0. 1-0.3 mm ,
I
C89 \
t
C73 \,
~
(O-C1))
\,"'- C90 / '
CB9 '-- - - /
2.10 Multiple exposure restrict plate (E88)
1) Remove temporarily attached E85.
2) E90, E89, E88 (apply G21 to inner diameter).
~:ss
L~
EBB~~ -
3) E85. Attach spring.
4) Check: Catch of C86 and E88 should be
more than two-thirds of the plate
thickness .
2.11 External LCD support plate (ElOl)
1) ElOl, CNL-D1.7 x2.5 x2
(Rear screw was omitted with early mass-produced items.)
2) Attach LCD display section of main PC Board.
CNL-Dl.7 x2.5 x2
2.12 Rear cover spacer (A322)
1) A322, CNL-Dl.7 x4.5 x2
2) Attach ML button flex (TlOO) to A322.
27340
CNL-Dl.7x2.5., ~
f?
CNl·01 7 x2~
CNL-Dl.7x4.Sn
15170