D59/D23; D37; D72/73 - Pentax 67 II Service Manual

6.18 D59 (Magnet plate), D23 (Magnet. plate retainer screw)
1) Insert D59 into the Mirror box and
screw tight with CNL-D l.7 x2.5 and
E9.l
2) Adjust : Position of S200 (H.c lease MG).
Loosen S200 screws (TY-CNL-B 1.4 x4.0 x2),
push down in .::--- direction shown in drawing,
adjust so that the armature shaft comes into contact
with the long hole of the amrnture and comes into
the center of the long hole,
and tighten TY-CNL-B 1.4 x4.0 x2.
E93
Center
-
Pushing dir11cliori
3) Charge the mirror and make sure that the stopper does not come loose.
The stopper should come off when electricity(l.7V) is apply to magnet.
4) Apply Three Bond (1401C) to TY-CNL-B 1.4 x4.0 x2.
6.19 D37 (FPC install plate)
1) Install D37 on the mirror box and
fix with CNL-D 1.7 xl.6 and CNL-D 1.7 x2.5.
-- cNL-D1.7xt.6
6.20 D72 (Wind-end SW fixed contact),
D73 (Wind-end SW moving contact)
(j)
Gap Wind-end sw
l. Install D72 and D73 with 0-Dl in
the charged state and fix with
CNL-Dl.7 x2.5.
2. At the mirror charged state.,
Check :
CD
Wind-completion SW gap.
0.5 mm
±-
0.1 mm
073
a
0 .5:!0.1mm
0
072
CNL -01 .7x2.5
®Tbe mirror restoring lever
should be stopped by contact
pressure of D72 and D7'.I.
3. Pass lead wire (purple) between 0-Dl
and the Mirror box.
44170