Mirror Charge Quantity - Pentax 67 II Service Manual

3) Adjust: Dislodge the linkage of the 0-ESO gears,
or replace 0-ESO with different gear and dowel positions.
(4 types, same part numbers)_,.
Adjust winding looseness and roughness by replacing with types
with different diameters .
- Diameter: O-E80-00A. (no sign)> -OOB (one mark-off line)> -OOC (two marks)
2.7 Mirror charge quantity (adjust) 801.0 x9
1) Place the winding lever in the preparatory
angle position.
2) O-D43 (-OOA: standard use), D6, LW15
Attach as shown in the drawing while
paying attention lo the O-D40 dowel
and the position of O-D43.
3) Check: Slowly wind. When the ratchet (O-C28) bas reversed
and the winding lever has returned, the Diaphragm
charge gear (O-D32) of the mirror box should be _,.
positioned on the left.
(-7 Charge completed state of the mirror box)
-040
0-043
Overcharge should occur when wound further up to the stopper.
4) Adjust: Di slodge the linkage oft.lie O-D43 gears or replace with another type.
- O-D43-00A (no mark), -OOB (one mark-off line), -OOC (2), -OOD (3)
A
8
c
D
NB : Be sure to apply G21 when replacing O-D43. Make sure that LW15 is not loose.
2.8 Duality prevention coupler lever (O-C25)
1) C98, O-C25, Wl (adj., 0.1- 0.3 mm), LWlO
Check: Vertical looseness less than 0.05 mm,
O-C25 should move smoothly.
2) Adjust: Attachment position of S300.
-1) Loosen screw CNL-Dl.7x3.5 as shown in drawing right,
adsorb the armature of S300. (S300 should be free)
-2) Slowly wind and return . When this is done, the tip of 0-E91
should move to the adsorption side of S300 an instant.
Adjust: Position S300, so that the above moving amount
reach to more than two-thirds of the width of
the S300 am1ature bole.
NB: When O-E91 move to adsorption side,
make sure that it is not distort.
S300 should not come into contact with the gear.
14/70 27340
0-EBO
1. 3.
~' ;~,"J\
CJ)
ct'
'
'