Installing the ETERNUS CS800 Components
Installing the Module
1. Install the DX80 module to the rack.
W
Figure 33: Tapes on the top of the DX80 module
2. Fasten the DX80 module in the rack.
Use the two thumb screws at the front of the DX80 module to fasten it in the rack.
Figure 34: Fasten the DX80 module in the Rack
U41842-J-Z125-1-76
CAUTION!
When installing the DX80 module to the rack, make sure to have the right and
●
left sides and the bottom of the controller enclosure by two or more people.
Failure to do so may cause injury.
Two pieces of tape are attached to the top of the DX80 module. Make sure that
●
this tape does not come off.
Installing the CS800 System in the Rack
55