Before Starting Up; Installation And Operation - Fujitsu ETERNUS CS800 Getting Started Manual

Safety Instructions

Before Starting up

V

Installation and Operation

V
14
CAUTION!
During installation and before operating the device, observe the instructions on
●
environmental conditions for your device.
If the system has been moved from a cold environment, condensation may form
●
both inside and on the outside of the machine.
Wait until the system has acclimatized to room temperature and is absolutely
●
dry before starting it up. Material damage may be caused to the system if this
requirement is not met.
Only transport the system units in the original packaging or in packaging that
●
protects it from impacts and jolts.
CAUTION!
This unit should not be operated in ambient temperatures above 35 °C.
●
If the unit is integrated into an installation that draws power from an industrial
●
power supply network with an IEC309 connector, the power supply's fuse
protection must comply with the requirements for non-industrial power supply
networks for type A connectors.
The unit automatically adjusts itself to a mains voltage in a range of 100-240 V
●
(50-60 Hz). Ensure that the local mains voltage lies within these limits.
This device must only be connected to properly grounded shock-proof sockets
●
or insulated sockets of the rack's internal power supply with tested and
approved power cables.
Ensure that the device is connected to a grounded shockproof socket close to
●
the device.
Ensure that the power sockets on the device and the grounded shockproof
●
sockets are freely accessible.
The On/Off button or the main power switch (if present) does not isolate the
●
device from the mains power supply. To disconnect it completely from the mains
power supply, unplug all network power plugs from the grounded shockproof
sockets.
Important Information
U41842-J-Z125-1-76