Fujitsu ETERNUS CS800 Getting Started Manual page 63

Hardware Description
Item Indicator, Button, Port
1 3 x USB ports
2 Monitor port (optional)
3 RST (Reset) button
4 NMI button
5 Power-on indicator
(green/orange)
/
ON/OFF button
6 Hard disk activity indicator
(green)
7 Global Error indicator
(orange)
U41842-J-Z125-1-76
Description
For connection with external devices
For connection with a monitor
Pressing the Reset button reboots the system.
V
CAUTION!
Risk of loss of data!
V
CAUTION!
Do not press! Risk of loss of data! The NMI
button may only be used by service.
Power-on indicator lights up green when the server is
switched on.
It lights up orange when the server is switched off, but
mains voltage is present (standby mode).
When the system is switched off, it can be switched on
again by pressing the ON/OFF button.
When the system is operating, pressing the ON/OFF
button will switch off the system.
I
The ON/OFF button does not disconnect the
server from the mains voltage. To disconnect
from the mains completely, remove the power
plug(s).
Lights up green when an internal drive (HDD or
backup drive) is being accessed.
Lights up orange if a prefailure event has been
detected that requires (precautionary) service inter-
vention.
Flashes orange if an error was detected that requires
service intervention.
Does not light up if there is no critical event.
If the event is still acute after a power failure, the
indicator is activated after the restart.
The indicator also lights up in standby mode.
CS800 Server
63