Installing The Drive - Fujitsu GP5-HD9G3 User Manual

1 Installing the Drive

To install and use this product with the mainframe of the teamserver, see the User's Guide
included with the mainframe. Before installation, setting pins, motor start mode, and SCSI-ID
must be set.
Locations of Setting Pins (GP5-HD9G3/GP5-HD8G1)
＜HDD printed DNES-xxxxxx on the label＞
(Bottom view)
＜HDD printed STxxxxxxLW on the label＞
(Over view)
Terminator power
supply setting
Setting at shipment: on (short)
All open
Motor start mode
at shipment: off (short)
All open
＜HDD printed MAHxxxxMP on the label＞
(Note) The product has no function for setting terminator.
As for GP5-HD9G3C and GP5-HD8G1C, SCSI-ID has been set in "#5" since factory
shipments.
Pin number: 7
Terminator power supply setting
Setting at shipment: ON (Short)
(Bottom view)
(Bottom view)
(Side view)
Motor start mode
at shipment: off (open)
6 5 4 3 2 1
ID1
ID0
SCSI ID
at shipment: #15
All open
Motor start mode
at shipment: off (open)
(Side view)
ID1 ID2
ID3
ID0
All Open SCSI ID
at shipment: #15
(Side view)
ID2 ID1
ID0
ID3
SCSI ID
at shipment: #15
All open
(Side view)
ID2
ID3
All open
Terminator power supply
setting
Setting at shipment: on (short)
E
1