Cabling The Expansion Modules (Optional) - Fujitsu ETERNUS CS800 Getting Started Manual

Installing the ETERNUS CS800 Components
V

Cabling the Expansion Modules (optional)

1. Connect a power cable to each power supply.
I
2. Connect each DX80 module with the next one via two SAS cables.
I
Figure 38: Cabling the DX80 modules
U41842-J-Z125-1-76
CAUTION!
The LAN cables in DX80 must be plugged into the MNT ports and not into the
RMT ports.
It is recommended that you connect each expansion module power cord (two
per module) to a separate AC circuit to ensure system availability in case of a
power failure.
The SAS cables MUST be connected exactly as shown in
connect the SAS cables to the correct ports will result in data corruption and/or
potential data loss.
Cabling the ETERNUS CS800 System
figure 38. Failure to
59