Important Information
V
U41842-J-Z125-1-76
CAUTION!
Always connect the CS800 components and the attached peripherals to the
●
same power circuit. Otherwise you run the risk of losing data if, for example, the
CS800 server unit is still running but a storage subsystem fails during a power
outage.
Data cables must be adequately shielded.
●
The EN 50173 and EN 50174-1/2 standards apply for LAN cabling. The
●
minimum requirement is the use of a category 5 screened LAN cable for
10/100 Mbit/s Ethernet, or a category 5e cable for Gigabit Ethernet. The
requirements from the ISO/IEC 11801 specification must also be met.
Route the cables in such a way that they do not create a potential hazard (make
●
sure no-one can trip over them) and that they cannot be damaged.
Never connect or disconnect data transmission lines during a storm (risk of
●
lightning strike).
Make sure that no objects (e.g. jewelry, paperclips etc.) or liquids can get inside
●
the system (risk of electric shock, short circuit).
In emergencies (e.g. damaged casing, controls or cables, penetration of liquids
●
or foreign bodies), switch off the system immediately, remove all power plugs
and contact your sales outlet or customer service team.
Proper operation of the system (in accordance with IEC 60950-1/ EN 60950-1)
●
is only ensured if the casing is completely assembled (electric shock, cooling,
fire protection, interference suppression).
Only install system expansions that satisfy the requirements and rules
●
governing safety and electromagnetic compatibility and those relating to
telecommunication terminals. If you install other expansions, they may damage
the system or violate the safety regulations. Information on which system
expansions are approved for installation can be obtained from our customer
service center or your sales outlet.
The components marked with a warning notice (e.g. lightning symbol) may only
●
be opened, removed or exchanged by authorized, qualified personnel.
Exception: CRU (Customer Replaceable Units) components can be replaced.
The warranty is void if the system is damaged during installation or replacement
●
of system expansions.
Only set screen resolutions and refresh rates that are specified in the operating
●
manual for the monitor. Otherwise, you may damage your monitor. If you are in
any doubt, contact your sales outlet or customer service center.
Safety Instructions
15