Installing The Hood; Lubrication; Greasing Bearings And Bushings - Toro Workman HD 07369 Operator's Manual

Figure 32
1. Hood
2. Pivot the bottom of the hood upward until the top
mounting tabs can be pulled from the frame slots
(Figure 32).
3. Pivot the top of hood forward and unplug the wire
connectors from the head lights (Figure 32).
4. Remove the hood.

Installing the Hood

1. Connect the lights.
2. Insert the top mounting tabs into the frame slots.
3. Insert the lower mounting tabs into the frame slots.
4. Ensure that the hood is fully engaged in the top, sides
and bottom grooves.

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 100 hours (Lubricate more frequently
in heavy duty applications)
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
The grease fitting locations and quantities are as follows:
•
Ball joints (4), tie rods (2), pivot mounts (2) and steering
cylinder (2) (Figure 33)
•
Spring tower (2) (Figure 34)
•
Clutch (1), accelerator (1), brake (1) (Figure 35)
•
U-joint (18) (Figure 36)
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
33
Figure 33