Installing The Full Bed - Toro Workman HD 07369 Operator's Manual

Figure 27
1. Bed mounting plate
2. Cylinder rod end
3. Clevis pin
4. Remove the clevis pins securing the cylinder rod ends
to the bed mounting plates by pushing the pins towards
the inside (Figure 28).
5. Remove the lynch pins and clevis pins securing the
pivot brackets to the frame channels (Figure 28).
6. Lift the bed off of the machine.
CAUTION
The full bed weighs approximately 147.5 kg
(325 lb), so do not try to install or remove it by
yourself. Use an overhead hoist or get the help
of two or three other people.
7. Store the cylinders in the storage clips.
8. Engage the hydraulic lift lock lever on the machine to
prevent accidental extension of the lift cylinders.

Installing the Full Bed

Note: If the bed sides will be installed on the flat bed, it is
easier to install them before installing the bed on the machine.
Note: Ensure that the rear pivot plates are bolted to the bed
frame/channel so that lower end angles to the rear (Figure 28).
4. Lynch pin
5. Rear slots (Full bed)
6. Front slots (2/3 bed)
1. Left rear corner of bed
2. Machine frame channel
3. Pivot plate
Note: Ensure that the spacer brackets and wear blocks
(Figure 29) are installed with the carriage bolt heads
positioned inside the machine.
1. Spacer bracket
2. Wear block
1. Ensure that the lift cylinders are fully retracted.
2. Carefully set the bed onto the machine frame aligning
the rear bed pivot plate holes with the holes in the rear
frame channel and install 2 clevis pins and lynch pins
(Figure 28).
3. With the bed lowered, secure each cylinder rod end, to
the appropriate slots in the bed mounting plates with a
clevis pin and lynch pin.
4. Insert the clevis pin from outside of the bed with the
lynch pin toward the outside (Figure 28).
31
Figure 28
4. Clevis pin
5. Lynch pin
Figure 29
3. Carriage bolt