Table of Contents
Advertisement
transmission shift rod, align the knob so that the shift
pattern is legible, and tighten the jam nut
9. Thread the control knobs that you removed in step
of
Removing the Center-Console Covers (page 5)
the rods for the transmission lever (Workman models
with an automatic transmission), hydraulic-lift, and the
speed-range lever
(Figure
17
Installing the Hood
No Parts Required
Procedure
1. Align the bottom of the hood to the top of the bumper
(Figure
4).
2. Connect the lights.
3. Insert the top mounting tabs into the frame slots
(Figure
4).
4. Insert the lower mounting tabs into the pockets in the
bumper
(Figure
4).
5. Ensure that the hood is fully engaged in the top, sides,
and bottom grooves
18
Installing the Bed
No Parts Required
Procedure
For Workman models with a utility bed, install the bed onto
the machine; refer to the Operator's Manual for your Workman
model for the bed installation procedure.
(Figure
6).
(Figure
4).
Operation
8).
4
Using the Remote Hydraulics
onto
Manifold
Important: If the 3-position switch is left in the ON
position, and the engine is shut off, the battery will drain
from the solenoids in the manifold being energized.
Make sure that you set the 3-way switch to the Off
position before you shut off the engine.
•
If the bed operates backwards, switch the 2 hoses
connected to the 90 degree fittings on the manifold.
Important: Make sure that you cycle the bed lift
lever several times in order to release/equalize the
pressure in the bed lift cylinders before removing
the hoses.
•
The dump bed will operate normal when the 3-position
switch is in the OFF position. Turning the 3-position
switch ON will deactivate the bed and activate the quick
coupler connections.
21
Advertisement
Table of Contents
