Fuel System Maintenance; Replacing The Fuel Filter; Inspecting The Fuel Lines And Connections; Electrical System Maintenance - Toro Workman HD 07369 Operator's Manual

Fuel System
Maintenance

Replacing the Fuel Filter

Service Interval: Every 400 hours
1. Raise the bed (if so equipped) and place the safety
support on the extended lift cylinder to hold up the
bed.
2. Place a clean container under the fuel filter (Figure 41).
Figure 41
1. Fuel filter
3. Loosen the R-clamp securing the filter to the frame.
4. Remove the clamps securing the fuel filter to the fuel
lines.
5. Install a new fuel filter to fuel lines with the clamps
previously removed. The filter must be mounted so
the arrow points toward the carburetor.
6. Tighten the R-clamp securing the filter to the frame.
7. Wipe up and spilled fuel.
Inspecting the Fuel Lines and
Connections
Service Interval: Every 400 hours/Yearly (whichever comes
first)
Every 1,000 hours/Every 2 years (whichever comes
first)
Inspect the fuel lines and connections for deterioration,
damage, or loose connections.
Electrical System
Maintenance

Servicing the Fuses

The fuses for the machine's electrical system are located
under the center of the dash panel (Figure 42 & Figure 43).
1. Fuses
37
Figure 42
Figure 43