Replacing The Hydraulic Filter; Raising The Box In An Emergency - Toro Workman HD 07369 Operator's Manual

1. Hydraulic strainer
5. Install the strainer.
6. Install the hydraulic hose and 90 degree fitting to the
strainer in the same orientation.
7. Install and tighten the drain plug.
8. Fill the reservoir with approximately 7 L (7.5 qt) of
Dexron III ATF. Refer to Checking the Hydraulic Fluid
Level.
9. Start the engine and operate the machine to fill the
hydraulic system. Check the hydraulic oil level and
replenish it, if required.
Important: Use only the hydraulic fluids specified.
Other fluids could cause system damage.

Replacing the Hydraulic Filter

Service Interval: After the first 10 hours
Every 800 hours
Important: Use of any other filter may void the warranty
on some components.
1. Position the machine on a level surface, stop the
engine, engage the parking brake, and remove the key
from ignition switch.
2. Clean the area around filter mounting area. Place a
drain pan under the filter and remove the filter (Figure
64).
Figure 63
1. Hydraulic filter
3. Lubricate the gasket on the new filter.
4. Ensure that the filter mounting area is clean. Screw the
filter on until the gasket contacts the mounting plate.
Then tighten the filter one-half turn.
5. Start the engine and let it run for about two minutes to
purge air from the system. Stop the engine and check
the hydraulic oil level and for leaks.
Raising the Box in an
Emergency
The box can be raised in an emergency without starting the
engine by cranking starter or by jumping hydraulic system.
Raising the Box using the Starter
Crank the starter while holding the lift lever in the Raise
position. Run the starter for 15 seconds then wait 60 seconds
before engaging the starter again. If the engine will not crank,
you must remove the load and box (attachment) to service
the engine or transaxle.
Raising the Box by Jumping the
Hydraulic System
CAUTION
Before servicing or making adjustments to the
machine, stop the engine, set the parking brake, and
remove the key from the switch. Any load material
must be removed from the bed or other attachment
before working under a raised bed. Never work
under a raised bed without positioning the safety
support on the fully extended cylinder rod.
Note: 2 hydraulic hoses, each with a male and female quick
coupler, that fit the machine couplers are required to perform
this operation.
1. Back another machine up to the rear of the disabled
machine.
Important: The machines hydraulic system uses
Dexron III ATF. To avoid system contamination,
46
Figure 64