Specifications - Toro Workman HD 07369 Operator's Manual

Light Switch
Push the light switch (Figure 6), to toggle the headlights on
or off.
Oil Pressure Warning Light
The oil pressure warning light glows (Figure 6) if the engine
oil pressure drops below a safe level while the engine is
running. If the light flickers or remains on, stop the machine,
turn off the engine, and check the oil level. If the oil level was
low, but adding oil does not cause the light to go out when
the engine is restarted, turn the engine off immediately and
contact your local Toro distributor for assistance.
Check the operation of warning lights as follows:
1. Apply the parking brake.
2. Turn the ignition key to the On position, but do not
start the engine.
Note: The oil pressure light should glow red. If the light
does not function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.
Note: If engine was just turned off, it may take 1 to 2
minutes for the light to come on.
Charge Indicator
Illuminates when the battery is being discharged. If the light
illuminates during operation, stop the machine, turn off the
engine and check for possible causes (Figure 6).
Important: If the alternator belt is loose or broken, do
not operate the machine until adjustment or repair is
complete. Failure to observe this precaution may result
in damage to the engine.
Check the operation of warning lights as follows:
•
Apply the parking brake.
•
Turn the ignition key to the On position, but do not start
the engine. The charge indicator and oil pressure lights
should glow. If any light does not function, either a bulb
is burned out or there is a malfunction in the system
which must be repaired.
Fuel Gauge
The fuel gauge shows the amount of fuel in the tank. It
operates only when ignition switch is in the On position
(Figure 6). Red indicates low fuel level and blinking red
indicates near empty.
Power Point
Use the power point (Figure 6) to power optional 12 volt
electrical accessories.
Choke
To start a cold engine, close the carburetor choke by pulling
the choke control (Figure 6) out to the On position. After the
engine starts, regulate the choke to keep the engine running
smoothly. As soon as possible, open the choke by pushing
in the choke control to the Off position. A warm engine
requires little or no choking.
Passenger Hand Hold
The passenger hand hold is located on the dashboard (Figure
7).
1. Passenger hand hold
Seat Adjusting Lever
The seats can be adjusted fore and aft for operator comfort
(Figure 8).
1. Seat adjusting lever

Specifications

Note: Specifications and design are subject to change
without notice.
Dimensions
15
Figure 7
2. Storage compartment
Figure 8