Ignition Switch; Parking Brake; Hour Meter - Toro Workman HD 07369 Operator's Manual

1. Gear shift lever

2. Parking brake

3. Hydraulic bed lift
Parking Brake
Whenever the engine is shut off, the parking brake (Figure
5) must be engaged to prevent accidental movement of the
machine. To engage the parking brake, pull back on the lever.
To disengage, push the lever forward. Release the parking
brake before moving the machine. If you park the machine on
a steep grade, apply the parking. Also, shift the transmission
into 1st gear on a uphill grade or reverse on a down hill grade.
Place chocks at the down hill side of the wheels.
Hydraulic Lift
The hydraulic lift raises and lowers bed. Move it rearward to
raise the bed, and forward to lower it (Figure 5).
Important: When lowering the bed, hold the lever in
the forward position for 1 or 2 seconds after the bed
contacts the frame to secure it in the lowered position.
Do not hold the hydraulic lift in either the raise or lower
position, for more than 5 seconds, once the cylinders
have reached the end of their travel.
Hydraulic Lift Lock
The hydraulic lift lock locks the lift lever so the hydraulic
cylinders do not operate when the machine is not equipped
with a bed (Figure 5). It also locks the lift lever in the On
position when using the hydraulics for attachments.
High–Low Range Shifter
The high–low range shifter adds 3 additional speeds for
precise speed control (Figure 5).
•
The machine must be completely stopped before shifting
between High and Low range.
•
Shift only on level ground.
•
Press clutch pedal fully.
•
Move the lever fully forward for High and fully rearward
for Low.
Figure 5
4. Hydraulic lift lock
5. Differential lock
6. High–low range shifter
High is for higher speed driving on level, dry surfaces with
light loads.
Low is for low speed driving. Use this range when greater
than normal power or control is required. For example, steep
grades, difficult terrain, heavy loads, slow speed but high
engine speed (spraying).
Important: There is a location between High and Low
in which the transaxle is in neither range. Do not use
this position as a neutral position because the machine
could move unexpectedly if the High–Low shifter is
bumped and the gear shift lever is in gear.

Ignition Switch

Use the ignition switch (Figure 6) to start and stop the
engine. It has 3 positions: Off, Run, and Start. Rotate the key
clockwise to the Start position to engage the starter motor.
Release the key when the engine starts. The key will move
automatically to the On position. To shut the engine off,
rotate the key counterclockwise to the Off position.
1. Light switch
2. Choke

3. Hour meter

4. Fuel gauge
5. Ignition switch
Hour Meter
Indicates the total hours of machine operation. The hour
meter (Figure 6) starts to function whenever the key switch is
rotated to the On position or if the engine is running.
3rd High Lockout Switch
Move the 3rd high lockout switch (Figure 6) to the slow
position and remove the key to prevent the use of third gear
when in the High range. The engine will shut off if the shift
lever is moved to third gear when in High range. The key is
removable in either position.
14
Figure 6
6. Power point
7. 3rd high lockout switch
8. Oil pressure warning light
9. Charge indicator