Checking The Carburettor Heating Circuit; Checking The Starter Circuit - PEUGEOT Django 125 Workshop Manual

ELECTRICITY

Checking the carburettor heating circuit

Power supply range of the carburettor heating
resistor:
between 10±2 and 20±2 °C.
Disconnect the temperature control unit and
take the measurements on the harness side.
- Between the green wire and the ground: 0 Ω
- Between the white/yellow wire and the ground
(Resistor warming carburator):9.5 Ω
- Between the black wire and the ground, ignition
on: 12V (Battery voltage).
- Between the yellow wire and the ground, engine
running: 13.5V (Regulated alternating current).
If the values
temperature control unit.
If the values are incorrect, check:
• The harness.
• The ignition switch.
• The carburettor heating resistor : 9.5 Ω

Checking the starter circuit.

Checking the starter resistance:
- Disconnect the limiting resistance.
- Measure the value of the resistance between
the resistor wire and the earth: 5 Ω
Checking the electric starter
- Removal of the electric choke.
- Connect the starter to a battery. The starter
piston should retract.
76
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
±20%
are correct, replace
±20%
.
the
±20%
.
.
Ω
+
-