PEUGEOT Django 125 Workshop Manual page 52

- Connect the reservoir containing brake fluid to
the modulator bleed screw using a transparent
pipe. The reservoir must be kept higher than the
modulator to easily check that the air bubbles are
being expelled.
- Open the bleed screw by 1 to 2 turns.
- Actuate the LH brake lever in an even way and
without undue haste while topping up with brake
fluid in the master cylinder.
Don't lean over the master cylinder when
bleeding the circuit in order not to get
splashed by brake fluid
- Stop the operation when no more bubbles are
expelled from the modulator bleeder screw.
- Close the bleeder screw.
- Connect the reservoir containing brake fluid to
the front brake calliper bleed screw using a
transparent pipe. The reservoir must be kept
higher than the brake calliper to easily check that
the air bubbles are being expelled.
- Open the bleed screw by 1 to 2 turns.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
SERVICE OPERATIONS
51