SERVICE OPERATIONS
Removal of the spark plug
Note:
400cc engine: 1 spark plug
500cc engine: 2 spark plugs
- Remove the access door. (Left side)
- Disconnect the suppressor.
- Remove the spark plug.
Essential precautions: When re-installing,
srew in the spark plug (a few turns)
by hand. For torquing, use a spark
plug wrench equipped with a dial.
- Tighten the spark plug.
Tightening torque: 1.2 m.daN.
Draining the cooling circuit
Note: The cooling system is drained when
the engine is cold.
- Remove the footboards. See: Procedure 6.
Page: 34.
- Remove the header tank cap.
- Disconnect the water pump and cylinder
head hoses. (1 and 2)
46
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
2