Bleeding The Circuit After Removing A Front Or Rear Caliper, A Front Or Rear Lower Hydraulic Hose - PEUGEOT Elystar Workshop Manual

Bleeding the circuit after removing a front or rear caliper, a front or rear lower hydraulic hose

Operation 1
- Remove the cover from the master cylinder to be bled
- Protect any plastics which may be exposed to brake fluid splashes
- Remove the caliper bleed screw cap
Note: If the integral circuit is to be bled (left
lever), the right lever must be immobilised with a
hook or cable tie (as described in the note on page
30).
- Connect the bleed screw to a recipient containing
brake fluid using a transparent pipe. The recipient
must be kept higher than the brake caliper to
facilitate checking that the air bubbles are being
expelled.
- Open the caliper bleed screw half a turn
- Position the handlebar in order to set the master
cylinder horizontal
Important: It is essential to avoid being under the
master cylinder during bleeding to avoid brake
fluid splashes
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
WORKING ON THE ABS/PBS SYSTEM
Page : 37