Yamaha F50D Servise Manual page 71

1
∫
4
2
å H model
∫ R model
2. Set the shift lever to the "N" position and
throttle grip to the fully-closed position.
(H model)
Set the remote control lever to the "N"
position and throttle lever to the fully-
closed position. (R model)
3. Fully screw in the shift cable joint 5 to
the shift cable (rod) 6.
5
4. Check that the center of the bushing a
is aligned with the alignment mark b on
the bracket.
Wiring harness connection / Control cable installation
3
6
5. Adjust the shift cable joint 5 to the pin c
of shift lever. NOTICE: The shift cable
joint must be screwed in a minimum
of 8.0 mm (0.31 in) d.
6. Install the shift cable joint 5 to the pin c,
and then tighten the locknut 7. Then
install the clip 8.
5 d 7
c
TIP:
Pull the inner cable to avoid the free play
(backlash) of the cable, and install it to the
pin. (R model)
7. Fully screw in the cable joint 9 to the
throttle cable 0.
9
a
b
5
8
0
3-14
0
1
2
3
4
5
6
7
8
9
10
A