Yamaha F50D Servise Manual page 307

q
0
y
u
t
9
y
e
w
Self-locking nut t:
23 N·m (2.3 kgf·m, 17.0 ft·lb)
Grease nipple u:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
Adjusting the trim sensor
1. Fully tilt the swivel bracket down.
2. Measure the trim sensor resistance.
Adjust the trim sensor by following steps,
if out of specification.
P
B
Trim sensor setting resistance:
Pink (P)–Black (B)
9.0–11.0 Ω at 20 °C (68 °F)
Steering arm, swivel bracket, and clamp brackets
r
0
q
y
u
t
3. Fully tilt the swivel bracket up, and then
support it with the tilt stop lever 1.
1
4. Loosen the cam screws 2.
5. Adjust the position of the trim sensor 3,
and then tighten the screws 2 to the
specified torque.
3
a
2 b
Trim sensor cam screw 2:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
TIP:
9
To increase the resistance, turn the trim
sensor in direction a.
9 To decrease the resistance, turn the trim
sensor in direction b.
6. Fully tilt the swivel bracket down, and
then measure the trim sensor resistance
again.
0
1
2
3
4
5
6
7
8
9
10
A
9-28