Using Intercom As The Line For Autodial - Nortel P0857846 System Coordinator Manual

56 / Time savers for making calls
If you select a line before pressing the autodial button, the call will
go out on the line you have selected instead of the line that is part of
the autodialer programming.
For the M7100 telephone, an external autodialer can only be
programmed using a line and not a line pool.
Tip -
autodial number, the call will use your prime line (if
you have one).

Using intercom as the line for Autodial

If you press
you must include a valid line pool access code or a destination code.
If line pool access codes or destination codes are changed,
remember to reprogram autodial numbers as well.
Displays
Norstar-PLUS Modular ICS 2.0 System Coordinator Guide
If you do not include a line selection in an
∆
as the line for an external autodial number,
Continue to enter digits until the number is
complete. Press
erase an incorrect digit. Press
OK
The memory allotted to autodial numbers in
your Norstar system is full.
While programming external Autodial, you
erased the button by pressing
OK
Enter the number you wish to program
(choosing the line first if necessary) exactly
as you would if you were making a call.
Enter the internal telephone number you
wish to program.
You are programming an internal autodial
button and have entered a number that is not
an internal number on your system. Enter a
valid internal number. If the number you are
entering is a destination code, use external
autodial.
√
when you are finished.
before entering any digits.
˙
or BKSP to
or
˙
or
P0857846 Issue 02