Daikin FT25CV1A Service Manual page 82

Si01-406
I To use ON TIMER operation
• Check that the clock is correct. If not, set
the clock to the present time
(page 9.).
1. Press "ON TIMER button".
is displayed.
blinks.
2. Press "TIMER Setting button"
until the time setting reaches
the point you like.
• Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either but-
ton changes the setting rapidly.
3. Press "ON TIMER button"
again.
• The TIMER lamp lights up.
ON
OFF
I To cancel ON TIMER
operation
4. Press "CANCEL button".
• The TIMER lamp goes off.
I To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
I I I I In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
System Configuration
(Example)
Present time: 11:00 PM
(The unit operating)
OFF TIMER at 0:00 a.m.
Combined
ON TIMER at 7:00 a.m.
C
HOME LEAVE
ON/OFF
TEMP
POWERFUL
MODE FAN SWING
SILENT SENSOR
ON CANCEL
OFF
TIMER
Instructions
1, 3
2
4
71