Lcd Message List - Oki C3530nMFP Maintenance Manual

7.5.1 LCD Message List

(1) Status. Warning. Alarm
(1)-(a) Status during idle mode
The Staus.Warning.Alarm list is recorded in table 7-1-1.
No. Level
This message appears immediately after power is turned
on and before the CU firmware starts up.
1 Initializing
The controller is being initialized.
"OKI PRINTING SOLUTIONS" Logo is displayed.
2 Initializing
The controller's EEPROM is being reset.
The EEPROM is reset under one of the conditions below.
・ Change of CU ROM (CU F/W version is detected
unmatched)
3 Initializing
・ Change of destination
・ Forced initialization of EEPROM (system maintenance
menu)
・ OEM set by PJL command
RAM check is in progress. The number (nnn) in Line 2
represents the percentage of checked capacity against the
total capacity.
4 Initializing
The PU firmware is starting up in Loader mode.
This error may occur in a user environment. In that case,
the printer requires servicing by an engineer (equivalent to
5 Initializing
S/C).
Communications with PU firmware has failed.
This error may occur in a user environment. In that case,
the printer needs servicing by an engineer (equivalent to
6 Initializing
S/C).
43605601TH Rev. 1
Function
Oki Data CONFIDENTIAL
Status Message
1 Initializing
2
3
4
5
1 "OKI PRINTING SOLUTION"
2 Bitmap Image
3
4
5
1 EEPROM Reset
2
3
4
5
1 RAM Check
2 nnn%
3
4
5
1 PU Flash Error
2
3
4
5
1 Communication Error
2
3
4
5
PJLStatusCode
-
-
-
-
-
-
122 /