MAINTENANCE WORK ON FRAME AND ENGINE
Checking the headlight setting
9.46
A
0 0 A
Adjusting the headlight range
9.47
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread with a
soft jerk. Tighten the screw slightly.
–
Check that the turn signal system is functioning properly.
–
On a light-colored wall behind a horizontal area, make a mark as high as the center of
the low beam headlight.
–
Make another mark at a distance of
Guideline
0 0 B
B
Distance
–
Stand the motorcycle at a distance of
beam.
Guideline
400726-10
Distance
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a motor-
cycle with driver.
»
If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. (
–
Check the headlight setting. (
under the first mark.
5 cm (2 in)
in front of the wall and switch on the low
5 m (16 ft)
p. 100)
p. 100)
100