Connecting The Pc Ethernet Cable; Wall Mounting (Optional) - Avaya 1220 User Manual

Using your Avaya 1220 IP Deskphone
(PoE), your Avaya 1220 IP Deskphone can be powered through the LAN
port. Do not extend the LAN Ethernet cable outside the building.
1. Plug one end of the supplied LAN Ethernet cable into the LAN
Ethernet port on the back of your Avaya 1220 IP Deskphone as
shown in Figure 8 on page
2. Thread the cable through the channel in the foot stand (if installed).
3. Connect the other end of the cable to your LAN Ethernet connection.
The LAN LED on the back of the Avaya 1220 IP Deskphone lights
when a LAN connection is established.
Note: When your LAN cable gets unplugged on an active IP
Deskphone, your IP Deskphone LCD displays an alert message "LAN
cable unplugged".

Connecting the PC Ethernet cable

Connect a CAT5e PC Ethernet cable between your Avaya 1220 IP
Deskphone and your computer to enable your computer to access the
LAN.
1. Plug one end of the PC Ethernet cable (not supplied) into the PC
Ethernet port on the back of your Avaya 1220 IP Deskphone as
shown in Figure 8 on page
2. Thread the cable through the channel in the foot stand (if installed).
3. Connect the other end of the cable to the LAN port on your PC.

Wall mounting (optional)

You can mount your Avaya 1220 IP Deskphone on a wall. Wall-mount the
Avaya 1220 IP Deskphone using the two keyholes on the back of the it.
You do not need the foot stand for wall-mounted applications.
1. Remove the foot stand, if already attached.
2. Ensure all cables are properly routed and the Avaya 1220 IP
Deskphone is functioning.
3. Make small marks on the wall where you want to align each keyhole
slot.
48
45.
45.