Symbol PDT 8000 Product Reference Manual page 133

Connecting the Cradle
Setup the four-slot USB-to-Ethernet cradle as shown below:
Figure 4-17. Setting up the Four-Slot USB-to-Ethernet Cradle
Setting the Device IP Address
By default, the cradle will use DHCP to obtain its IP address. However, if DHCP fails, the
Cradle Manager can assign an IP address.
Note: This is used if your cradle is connected to the network, however fails
to appear in MobileDox. Enter the hardware device (MAC) address
to locate the cradle and assign it a new IP address.
1. Launch the MobileDox Cradle Manager on your host computer.
To Ethernet
Hub
Communications
4-33