Table of Contents
Advertisement
installation
|
30
SAFETY SCREEN
INSTALLATION- LOW PROFILE FACEPLATE
1. To remove safety screen, flip open bottom louver and remove 2 screws
in locations shown below.
STANDARD
FLUSH DOOR
NOTE: See Vignette or Low Profile Faceplate instructions for removal
of screen prior to removing glass. .
The standard flush door comes with a black frame. To install the frame, simply
hook the top door flange onto the top of the unit and swing the door towards
the unit, (Diagram 1 and 2). Be careful that the glass gasket does not roll up;
there must be a gap between the gasket and the door lip to ensure that the
door sits securely on the unit. Refer to Diagram 3.
Screws
Diagram 2
30 |
E33-10 FPI Direct Vent Gas Insert
Diagram 1
Diagram 2
2. Pull off safety screen and frame from glass door.
3. To install, reverse Steps 2-1.
Use the hook to pull the spring out until you can put the hook into the slot on
the bottom door bracket. Repeat for 2nd spring. See diagram 3.
To remove the flush door, reverse the above steps.
NOTE: The chain must rest on TOP of the gas inlet pipe never under it.
Diagram 3
Diagram 4
Diagram 5
Advertisement
Table of Contents
