Table of Contents
Advertisement
SPACER INSTALLATION FOR 3 SIDED VIGNETTE FACEPLATE
SPACER INSTALLATION FOR 3 SIDED VIGNETTE FACEPLATE
NOTE:
•
A spacer can be ordered, if required.
•
It is recommended to install spacer to the faceplate seper-
ately and then install both together to the unit.
1. Attach the side pieces of the spacer with 3 screws to both
sides of the vignette face plate.
2. Attach the top piece of the spacer to the vignette faceplate-
with 1 screw on each side.
919-578
3. Finally, attach the spacer to vignette faceplate (vignette
faceplate is purchased seperately) with 2 side screws on
the top (1 per side).
Completed Vignette faceplate with spacer.
4)
Proceed to faceplate installation- see "Optional Vignette
Faceplate Installation".
installation
E33-10
E33-10 FPI Direct Vent Gas Insert
|
23
5/26/15
|
23
Advertisement
Table of Contents
