Vignette Faceplate With Safety Screen Installation - Regency liberty LRI6E Owners & Installation Manual

installation
|
32

VIGNETTE FACEPLATE WITH SAFETY SCREEN INSTALLATION

VIGNETTE FACEPLATE W/ SAFETY SCREEN INSTALLATION
Black Chrome Handling Instructions
*
Failure to do this will result in burn stains on panels which you will be unable to remove.
1. Pop out tab on right side (facing front) of outer faceplate and place
grommet in opening to route power cord.
2. Install the outer faceplate and secure with 5 screws for the L/HRI4E
and L/HRI6E as shown.
Note: 4 corner screws can be installed on the unit loosely as the hole
on the outer faceplate are keyholes.
Route power cord on right side between the inner and outer profile of
faceplate. Use a grommet and wire clip to secure.
32 |
LRI6E / HRI6E Direct Vent Gas Insert
MUST
Pop out tab on right side
of outer faceplate
Power Cord
Location
VIGNETTE FACEPLATE
3. Install the Vignette faceplate by hooking the flange over the hanger
as shown.
4. Ensure finger prints or smudges are removed from the faceplate
before the first firing.
Final Install
Note: Shown with Optional Hearth Trim
NOTE: Pull the bottom of the Vignette faceplate towards you to access
the remote receiver.