Sided Low Profile Faceplate With Safety Screen Installation - Regency LRI4E Owners & Installation Manual

3 SIDED LOW PROFILE FACEPLATE WITH SAFETY SCREEN INSTALLATION

3 SIDED LOW PROFILE FACEPLATE W/SAFETY SCREEN INSTALLATION
Note: A mantel deflector may be installed to reduce the minimum mantel height.
Refer to minimum clearances in the installation manual.
If not installing the mantel deflector - proceed to step 3.
1. Line up the mantel deflector (tabs to the back) with the Low Profile
backing plate.
Mantel deflector
2. Bend all 3 tabs 90º to secure the deflector to the top of the backing plate.
The tabs should be flush with the underside of the top lip of the back plate.
Top of backing
plate
Note: Faceplate may be installed after the unit is in it's final position.
3. Install Low Profile faceplate backing plate and secure to the unit with 6
screws in locations shown below. Route power cord through the right side
of backing plate and install the grommet.
919-416
LRI4E / HRI4E / LRI6E / HRI6E
4. Install front faceplate by hooking back of front faceplate over lip edge on
unit in locations shown below. Angle faceplate slightly to hook on, lower
gently, bottom of faceplate will secure with magnets.
NOTE: To access the remote reciever pull lower portion of fron faceplate
Power Cord
1
Hooks on back of
front faceplate
Hook onto unit to install
Final Install
towards you. The receiver will be located on the lower left side of
the appliance.
LRI4E / HRI4E Direct Vent Gas Insert
installation
|
09.19.14
33
| 33