Table of Contents
Advertisement
VIGNETTE FACEPLATE WITH SAFETY SCREEN INSTALLATION
VIGNETTE FACEPLATE W/ SAFETY SCREEN INSTALLATION
Black Chrome Handling Instructions
*
All hand and finger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any
finger prints before applying heat to the unit. Use supplied gloves when installing Black Chrome Faceplates.
Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty.
1. Pop out tab on right side (facing front) of outer faceplate and place
grommet in opening to route power cord.
2. Install the outer faceplate and secure with 5 screws for the L/HRI4E
and L/HRI6E as shown.
Note: 4 corner screws can be installed on the unit loosely as the hole
on the outer faceplate are keyholes.
Route power cord on right side between the inner and outer profile of
faceplate. Use a grommet and wire clip to secure.
tooltip
Pop out tab on right side
of outer faceplate
Power Cord
Location
VIGNETTE FACEPLATE
3. Install the Vignette faceplate by hooking the flange over the hanger
as shown.
4. Ensure finger prints or smudges are removed from the faceplate
before the first firing.
Final Install
Note: Shown with Optional Hearth Trim
NOTE: Pull the bottom of the Vignette faceplate towards you to access
the remote receiver.
LRI6E / HRI6E-11 Direct Vent Gas Insert
installation
| 41
Advertisement
Table of Contents
