Table of Contents
Advertisement
LRI4E/HRI4E/LRI6E/HRI6E/E33
OPTIONAL HEARTH TRIM INSTALLATION- VIGNETTE FACEPLATE WITH SPACER AND LOW
OPTIONAL HEARTH TRIM INSTALLATION -VIGNETTE FACEPLATE WITH SPACER
PROFILE FACEPLATE
AND LOW PROFILE FACEPLATE
Customizing the Hearth Trim:
The Hearth Trim can be adjusted to custom fit an installation by pulling
apart the top piece from the bottom piece. Minimum height of the hearth
trim is 2" and can be adjusted upto maximum 6".
1) Cut the top of the bottom piece of the hearth trim to the appropriate
height using a metal cutting blade.
NOTE: The tab bends at the back of the top piece of the hearth trim
should be used as the measuring point to the hearth to measure the
height required.
2) Reattach the top piece of the hearth trim to the cut bottom piece by
fitting in place.
3) Similar to the front hearth trim, cut the top of the bottom piece of the spacer
brackets to the appropriate height.
4) Attach the top and bottom part of the spacer brackets and then attach these
spacer brackets to the assembled hearth trim with 3 screws.
Attach the hearth trim and spacer bracket with 3 screws each side
919-560
Spacer Brackets
Spacer Brackets
installation
5) Secure the hearth trim with a clip on its side to keep it steady as shown in
the picture below .
Clip to keep hearth
trim steady
6) Line up the hearth trim with base of the unit and secure it with 3 screws
as shown below.
Align hearth trim to base of the unit and secure it with 3 screws
E33-10 FPI Direct Vent Gas Insert
|
27
04/30/15
|
27
Advertisement
Table of Contents
