Door Glass; Flush Glass Replacement; Fan Maintenance - Regency Energy E33-NG10 Owners & Installation Manual

DOOR GLASS

Your Regency stove is supplied with high
temperature, 5 mm Neoceram ceramic glass that
will withstand the highest heat that your unit will
produce. Do not abuse the glass by striking the
surface or by slamming the door shut.
If your glass requires cleaning, we recommend
using an approved glass cleaner available at
all authorized dealers. Do not use abrasive
materials. Do not clean the glass when hot.
In the event that you break your glass by impact,
purchase your replacement from an authorized
Regency dealer only, do not use substitute
materials. Follow our step-by-step instructions
for replacement. Warning: Wear gloves when
removing damaged or broken glass.
Caution: Do not operate appliance with
glass panels removed, cracked or broken.
Replacement of the glass should be done
by a licensed or qualified service person.

Flush Glass Replacement

Remove the flush door front (refer to the
"Standard Flush Door" section). Remove the 4
glass clips from each corner. Slide in the new
replacement glass. Push the 4 glass clips back
onto the frame.

FAN MAINTENANCE

If your fan requires maintenance or replacement,
access to the fan is through the plate on the
floor of the firebox. NOTE: the unit MUST NOT
be operated without the fan access panel
securely in place.
Caution: Label all wires prior to
disconnecting when servicing controls.
Wiring errors can cause improper and
dangerous operation. Verify proper
operation after servicing.
To Remove Fan:
1) Turn the unit off and allow it to cool down to
room temperature.
2) Unplug or disconnect power source to stove.
3) Remove the safety screen and glass door,
see instructions in manual.
4) Remove logs and grate -see manual for
details.
5) Remove optional brick panel set, if installed
(refer to the "Optional Brick Panel" section).
6) Remove base brick set. (When removing
base brick sides the two screws that hold
the grate down must be removed first).
Screws
7) Straighten the adjustment wire under the
firebox base.
Air Shutter Wire
Straighten adjustment wire.
8) Remove the Burner by removing the 2
screws (1 on burner bracket and one on
valve tray). Tilt up the left burner and slide
to the left away from the orifice.
Screws
maintenance
9) Remove the rear log support by unscrewing
the 2 screws.
Screws
10) Remove the 12 screws holding the Access
Panel in place.
Fan Access Plate Screws
11) Unplug the wires from the fan motor (from
inside the stove).
12) Remove the 2 screws from the fan
bracket.
Screws
E33-10 FPI Direct Vent Gas Insert
|
35
| 35