LRI4E/HRI4E/LRI6E/HRI6E/E33
installation
|
28
OPTIONAL HEARTH TRIM
OPTIONAL HEARTH TRIM INSTALLATION- VIGNETTE FACEPLATE WITHOUT SPACER
INSTALLATION - VIGNETTE
FACEPLATE WITHOUT SPACER
Customizing the Hearth Trim
The Hearth Trim can be adjusted to custom fit an installation by pulling
apart the top piece from the bottom piece. Minimum height of the hearth
trim is 2" and can be adjusted upto maximum 6".
1) Discard the spacer brackets, as these are not required when installing
the unit without spacer.
2. Cut the top of the bottom piece of the hearth trim to the appropriate
height using a metal cutting blade.
NOTE: The tab bends at the back of the top piece of the hearth trim
should be used as the measuring point to the hearth to measure the
height required.
3) Reattach the top piece of the hearth trim to the cut bottom piece by fitting
in place.
4) Line up the hearth trim with base of the unit and secure it with 3 screws as
shown below.
919-560
28 |
E33-10 FPI Direct Vent Gas Insert
04/30/15