LRI4E/HRI4E/LRI6E/HRI6E/E33
OPTIONAL HEARTH TRIM
OPTIONAL HEARTH TRIM INSTALLATION- VIGNETTE FACEPLATE WITHOUT SPACER
INSTALLATION -
VIGNETTE FACEPLATE WITHOUT SPACER
Customizing the Hearth Trim
The Hearth Trim can be adjusted to custom fit an installation by
pulling apart the top piece from the bottom piece. Minimum height
of the hearth trim is 2" and can be adjusted up to maximum 6".
1. Discard the spacer brackets, as these are not required when installing
the unit without spacer.
2. Cut the top of the bottom piece of the hearth trim to the appropriate
height using a metal cutting blade.
NOTE: The tab bends at the back of the top piece of the hearth trim
should be used as the measuring point to the hearth to measure
the height required.
3. Reattach the top piece of the hearth trim to the cut bottom piece by
fitting in place.
4. Line up the hearth trim with base of the unit and secure it with 3 screws
as shown below.
919-560
installation
E33-10 FPI Direct Vent Gas Insert
|
29
04/30/15
|
29