LOW PROFILE - OPTIONAL HEARTH TRIM INSTALLATION
Hearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi replace is higher than the hearth or to raise the fi replace.
1) For units L390E/HZI390E/L540E/HZI540E–remove 4 screws in
locations shown below to remove outer faceplate.
Diagram 1–Screw Locations
1a) For units U31/U32/E21/E33–remove outer faceplate by lifting up
and off backing plate.
Diagram 2–Lift off Front Faceplate
**If no holes are present on the backing plate, proceed to the Step 3.
2) If screw holes are present on backing plate, secure the hearth trim
to backing place with 2 screws on each side.
Hearth Trim
Diagram 3–Hearth Trim Secured to Backing Plate
U32SE-5 FPI Direct Vent Gas Insert
** If no screw holes are present.
3) Remove backing plate by removing 4 screws–lay down fl at.
Diagram 4–Backing Plate Removal Units L390E/HZI390E/L540E/
Diagram 5–Backing Plate Removal Units U31/U32/E21/E33
4) Secure hearth trim to backing plate with a clip on each side as
shown in Diagram 6. Ensure the hearth trim is evenly space on
either side of the backing plate.
Clip
Diagram 6–Hearth Trim Clip
5) Reinstall backing plate.
6) Reinstall outer faceplate.
INSTALLATION
HZI540E
Hearth Trim
31