Transmission (Gear Position) Switch; Turn Signal Switch (Intl); Hazard Switch (Intl) - Polaris 2012 RANGER RZR 570 INTL Service Manual

ELECTRICAL

Transmission (Gear Position) Switch

1. The transmission (gear position) switch is located on
the RH side of the transmission and can be accessed
through the RH wheel well area.
2. Disconnect the transmission switch harness by lifting
the connector loc k and pulling on the c onnector. Do
not pull on the wiring.
3. Test the transmission swit ch continuity readings for
each gear position and compare to th e specification
table below.
Gear Position
HIGH
LOW
NEU
REV
PARK
10.6
Resistance Value
when measured at switch terminals
A and B
24 Ohms
75 Ohms
160 Ohms
300 Ohms
620 Ohms
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.

Turn Signal Switch (INTL)

1. Disconnect the Tu rn Signal switch ha rness by
depressing the connector locks and pulling on the
connector. Do not pull on the wiring.
2. Test between the 5 set s of output s (H I BEAM / LO
BEAM / L-TURN / R-TURN / HORN). If any of the tests
fail, replace the switch assembly.
Orientation
Tab
1 2
HI BEAM
LO BEAM
L - TURN O
R - TURN O
HORN

Hazard Switch (INTL)

1. Disconnect wires or harness from the Hazard switch.
2. Test between the outputs (ON / NONE / OFF). If any
of the tests fail, replace the switch assembly.
• Move switch to ON. The re sh ould be continuity
between switch pins 2 and 3.
• Move switch to NONE / OF F. There should be no
continuity between switch pins.
3 4 6 7 8
O O
O O
O
O
O O
9