Installation; Front Stabilizer Bar; Stabilizer Bar Linkage Removal; Stabilizer Bar Removal - Polaris 2012 RANGER RZR 570 INTL Service Manual

Installation

1. Place the A-arm in the correct position for ball joint
installation. Face the A-a rm e nd flat on to p of the
driver. Carefully drive the ball joint into place until the
ball joint is properly seated.
Place driver HERE
to support A-arm
2. After the new ball joint is
install a NEW retaining ring.
Upper A-arm
Retaining Ring
3. Reinstall the A-arm (see "FRONT A-ARMS - Removal
/ Replacement").
4. Repeat the b all jo int ser vice procedure for an y
additional A-arm ball joint replacements.
Press into the A-arm
in this direction
Upper A-Arm Shown
installed into the A-arm,
Ball Joint
NEW
Standard RZR Shown
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
BODY / STEERING / SUSPENSION

FRONT STABILIZER BAR

Stabilizer Bar Linkage Removal

1. Elevate and safely support the front of the vehicle.
2. Remove the lower shock mounting fastener from the
upper A-a rm on ea ch side
"Exploded View").
3. Remove the up per portion of the linkage from the
stabilizer bar on each s ide of the v
"Exploded View"):
4. Inspect the linkage assemblies for signs of excessive
wear or da mage. Re place lin kage a ssembly if
damaged.
5. Reverse th e procedure fo r in stallation. To rque the
linkage fasten ers to spe cification ( see "Exploded
View").

Stabilizer Bar Removal

1. If stabilizer bar linkages are installed, remove the nut
and linkage bushings (see "Exploded View").
2. Remove the hood and fro nt b umper ( see " BODY
COMPONENT REMOVAL").
3. Remove the (4) T30 Torx fasteners retaining the front
bumper support to the frame.
Main
Frame
NOTE: Properly support th e bumpe r support an d
wires that are attached.
of the vehicle (see
ehicle (see
5
T30
Screws
Nuts
Bumper
Support
5.21