Brake Light Switch; Parking Brake Switch (Intl Model) - Polaris 2012 RANGER RZR 570 INTL Service Manual

Brake Light Switch

1. The br ake switch ca n be acce ssed thr ough the L H
rear wheel well area. The switch is located near the
outer PVT cover along th e lower fr ame. The b rake
pressure switch is installed into the cross fitting block.
Brake Switch
2. Disconnect wire harness from switch and connect an
ohmmeter acr oss switch co ntacts. The
should be infinite (OL).
3. Apply the brake and check for continuity. If there is no
continuity or if re sistance is gr eater tha n 0 .5 oh ms,
clean the switch terminals. Re-test and replace switch
if necessary.

Parking Brake Switch (INTL Model)

The p arking brak e s witch is located within the p arking
brake lever. Remove the rubber boot covering the parking
brake lever to locate the internally mounted switch.
PVT Cover
reading
The switch remains in the "open" position when the park
brake lever is not applied.
When the parking brake lever is applied, the switch makes
contact and sends volt age to the ECU to illuminate
"BRAKE" in th e in strument clu ster r ider in formation
display area (see "Park Brake Indicator").
NOTE: If the pa rking bra ke is applied th e ECU will
rev limit th e engine at 1500 RPM until the park ing
brake is relea sed. This f eature has be en ad ded t o
prevent drive-away with the parking brake applied.
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
ELECTRICAL
10
10.7