Polaris 2012 RANGER RZR 570 INTL Service Manual page 247

5. Install front wheel hub assembly, cone washers, and
hand tighten th e ca stle nut. Insta ll washers with
domed side out.
Cone Washers
Wheel
Hub
6. Install b rake caliper mo unting bo lts a nd torque to
specification.
Front Caliper Mounting Bolts:
31-34 ft. lbs. (42-46 Nm)
CAUTION
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
7. Install the steering tie rod end onto the front bearing
carrier.
NOTE: Refer t o the photos below to ens ure pr oper
placement of the tie rod end.
42.5 ft. lbs.
58 (Nm)
Out
= T
Tie Rod End
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
8. Torque the tie r od end fastener to spe cification and
install a new cotter pin.
Tie Rod End Fastener:
42.5 ft. lbs. (58 Nm)
9. Torque wh eel h ub n ut to spe cification and install a
new cotter p in. Tigh ten n ut slightly if ne cessary to
align cotter pin holes.
80 ft. lbs.
(108 Nm)
Wheel Hub Castle Nut:
80 ft. lbs. (108 Nm)
10. Install wheel and (4) wheel nuts. Torque wheel nuts
to specification.
Wheel Nuts:
Steel Wheels: 27 ft. lbs. (37 Nm)
Aluminum Wheels: 30 ft. lbs. + 90° (1/4 turn)
11. Rotate wheel and check for smooth operation. Bend
both en ds of cotte r pin around end of sp indle in
different directions.
FINAL DRIVE
= T
NEW Cotter Pin
= T
= T
7.5
7