Shift Cable; Inspection; Adjustment - Polaris 2012 RANGER RZR 570 INTL Service Manual

TRANSMISSION

SHIFT CABLE

Inspection

Shift cable adjustment may be nec essary if symptoms
include:
• No gear position or AWD display on instrument
cluster
• Ratcheting noise on deceleration
• Inability to engage into a gear
• Excessive gear clash (noise)
• Gear selector moving out of desired range
Inspect shif t cab le, clevis pin s, a nd pivot bu shings a nd
replace if worn or damaged.

Adjustment

1. Locate th e s hift ca ble a ttached to the transmission
case in the right rear wheel well area.
2. Inspect shift cable, clevis pin, pivot bushings, and dust
boot. Replace if worn or damaged.
Pin and
Bushings
Dust Boot
8.4
Shift Cable
Mount
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
3. If adjustment is required, loosen the lower jam nut and
pull the cable out of the mount to move the upper jam
nut.
4. Adjust the shift cable so there is the same amount of
cable travel when shifting slightly past HIGH gear and
PARK.
5. Thread th e up per or lower jam nu t a s r equired to
obtain proper cable adjustment.
NOTE: This procedure may require a few attempts to
obtain the proper adjustment.
6. Once th e pr oper adju stment is obtained, place th e
shift cable and upper jam nut into the mount. Tighten
the lower jam nut against the mount.
7. Start engine and shift through all gears to ensure the
shift c able is properly adjusted. If trans mission s till
ratchets after cable adjustment, the transmission will
require service.
Lower
Jam Nut
Upper
Jam Nut