Polaris 2012 RANGER RZR 570 INTL Service Manual page 80

ENGINE / COOLING SYSTEM
9. Remove the outer clutch cover , drive belt, dr ive clutch,
driven clutch and inner clutch cover (see Chapter 6).
Make note of hose and wire routings for reassembly.
IMPORTANT: Be sure to use the correct Drive Clutch
Puller (PA-48595) to prevent damage to crankshaft.
10. Disconnect the stator wire connector and cut the tie
strap secur ing the wir ing to th e fro nt eng ine mou nt
bracket. Replace tie strap for engine installation.
11. Remove the CPS sensor from the stator cover on the
right-hand sid e of the en gine. Plug CPS h ole with
clean shop towel. Inspect CPS O-ring and replace if
needed.
3.28
12. Disconnect the IAC valve (A), TPS (B), T-MAP sensor
(C), harness leads from the throttle body.
13. Disconnect the fuel injector harness lead (D) from the
fuel injector.
14. Properly relieve fuel pressure from the fuel rail.
15. Place a shop to beneath the fuel line quick connector
to catch any excess fuel. Disconnect the fuel line (E)
from the fuel rail by pressing in on the quick connector
tabs.
16. Move fue l line to th e left-h and sid e of th e en gine
compartment. Make note of
installation.
17. Disconnect the ignition coil har ness co nnector an d
remove the spark plug wire from the engine.
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
A
B
E
C
line routing for
D