Table of Contents
Advertisement
ELECTRICAL
AWD / 2WD / TURF SWITCH
11.86
TESTING
1. Disconnect the AWD / 2WD / TURF switch harness
by depressing the connector locks and pulling on the
connector. Do not pull on the wiring.
2. Test between the 3 sets of outputs (AWD / 2WD /
TURF). If any of the tests fail, replace the switch
assembly.
• Move the switch to AWD. There should be continuity
between switch pins 2 and 3.
• Move the switch to 2WD. There should be no
continuity between any pins.
• Move the switch to TURF. There should be continuity
between switch pins 1 and 2.
NOTICE
Pins 7 and 2 provide power and ground to light the
switch lamp.
TRANSMISSION / GEAR POSITION SWITCH
TESTING
1. The transmission (gear position) switch
on the RH side of the transmission and can be
accessed through the rear RH wheel well area.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
q
is located
© Copyright Polaris Industries Inc.
Advertisement
Chapters
Table of Contents
Troubleshooting
